Product Categories

Contact Us

Add:No.18, Tannan Road, Tanjia Industrial Village, Gongming Street, Guangming New District, Shenzhen, China

Tel:+86-755-22211988

Fax:+86-755-83768890

E-mail: frankwu@topscom.com.cn

News

Home > News > Content
Tooling Design Steps
Jul 12, 2017

  Tooling Design steps

  1. The feasibility of the design of the mold of the product analysis, the computer chassis, for example, the first component of the product design drawings using the design software analysis, that is, we work in the set diagram to ensure that the Tooling Design before the product drawings correct Sex, on the other hand can be familiar with the importance of each component in the entire chassis to determine the size of the key, so that the Tooling Design is very good, the specific set of map method here do not do a detailed introduction.

  2. In the product analysis to be carried out after the work of the product to analyze what kind of mold structure, and the product row process to determine the work of the workmanship, and the use of design software for product development, the product is generally from the follow-up project Forward, for example, a product requires five steps, stamping is completed in the product from the beginning of the product drawings to the four projects, three works, two projects, a project, and start a copy of a copy of the previous project To complete the work of the five projects to complete the work, and then carry out meticulous work, note that this step is very important, Tooling Design while the need to be particularly careful, this step to complete the good words, drawing mold will save a lot of time, After the stamping of each project to determine the content, including the mold in the mold, the thickness of the product material to retain the inner and outer lines to determine the size of the use of convex and concave mold, the method of product development is no longer described here, will be in the product development method Specific introduction.

  3. Preparation, according to the product development plan for preparation, in the drawings to determine the template size, including the fixed plate, unloading board, convex and concave mold, inserts, etc., pay attention to directly in the product development map preparation, Great advantage, I have seen a lot of Tooling Designers directly to the product diagram for manual calculation to prepare, this method is too low efficiency, Tooling Design directly on the drawings to draw the template size, to form a form of legislation, one Can be completed on the preparation of materials, on the other hand in the mold of the work of the accessories to save a lot of work, because the work in the drawing of the components only need to add in the preparation drawings positioning, pins, guide posts, screw holes can be.

  4. In the preparation of the material after the completion of the full access to the drawing of the mold, in the preparation of a copy of the drawings, the components of the drawing, such as adding screw holes, guide hole, positioning holes and other holes, and in the punching mold All kinds of holes need to cut the wire through the hole, in the mold, the upper and lower mold forming gap, must not forget, so these work is completed after a product of the mold has almost completed 80%, in addition to the process of drawing the mold Need to pay attention to: the process, refers to the production, such as pliers line, line cutting until the different processing processes have a complete production layer, so that the line cutting and drawing management has great benefits, such as the distinction between color, Tooling Design size The annotation is also a very important job, but also a most troublesome job, because it is a waste of time.

  5. Finally, after the completion of the above drawings, in fact, can not release the drawings, the need for proofreading of the mold drawings, all the accessories set up for each piece of different mold plate to create a different layer, and the same benchmark The mold set up the analysis, and the process of product development plans into the group diagram, to ensure that the template hole and the bending position of the upper and lower mold clearance with the correct.