Product Categories

Contact Us

Add:No.18, Tannan Road, Tanjia Industrial Village, Gongming Street, Guangming New District, Shenzhen, China

Tel:+86-755-22211988

Fax:+86-755-83768890

E-mail: frankwu@topscom.com.cn

News

Home > News > Content
Design Steps For Tooling Design
Aug 08, 2017

  Design steps for Tooling Design

  1, the design of the mold for the feasibility of the product analysis, the computer chassis, for example, the first component of the product design drawings using the design software analysis, that is, we work in the set diagram to ensure that the Tooling Design before the product drawings Of the correctness, on the other hand can be familiar with the importance of each component in the entire chassis to determine the size of the key, so that the Tooling Design is very good, the specific set of methods here do not do a detailed introduction.

  2, after the product analysis to be carried out by the work of the product analysis of what kind of mold structure, and the product row process to determine the work process of the work, and the use of design software for product development, when the product from the general Follow-up project to start, Tooling Design for example, a product requires the amount of five processes, stamping is completed in the product from the beginning of the product drawings to the four projects, three works, two projects, a project, and start a copy of a copy before A project to start the work, that is, the completion of the five projects to start the work, and then carry out detailed work, note that this step is very important, while the need to be particularly careful, this step to complete the good words, drawing mold will save a lot of time , After the stamping of each project to determine the content, including in the mold, the thickness of the product material to retain the inner and outer lines to determine the size of the use of convex and concave mold, Tooling Design the method of product development is no longer described here, will be launched in the product Method specifically described.

  3, metal Tooling Design mold CAD3, preparation, according to the product development plans for preparation, in the drawings to determine the template size, including the fixed plate, Tooling Design unloading board, convex and concave, inserts, etc., pay attention to the product directly in the map, This is a great advantage to the drawing of the mold, I have seen a lot of Tooling Designers directly to the product diagram for manual calculation to prepare, this method is too low efficiency, directly on the drawings to draw the template size, Group form of the form of expression, on the one hand can complete the preparation, on the other hand in the mold of the work of the accessories to save a lot of work, because the work of the components in the drawing only need to add the positioning drawings, pins, Screw hole can be.

  4, after the completion of the preparation can be fully into the mold drawing, drawing in the preparation of a copy of the drawings, the components of the drawing, such as adding screw holes, guide hole, positioning holes and other holes, and punch Mold in a variety of holes need to cut the wire through the hole, in the mold, the upper and lower mold forming gap, must not forget, so these work is completed after a product of the mold has almost completed 80%, while drawing the mold The process should pay attention to: the process, refers to the production, Tooling Design such as pliers line, line cutting until the different processing processes have a complete production of a good layer, so that the line cutting and drawing management has great benefits, such as the distinction between color , The size of the label is also a very important work, but also a most troublesome work, because it is a waste of time.

  5, after the completion of the above drawings, in fact, can not release the drawings, the need for proofreading of the mold drawings, all the components set up, for each piece of different mold plate to create a different layer, Tooling Design and the same benchmark The mold set up the analysis, and the process of product development plans set into the group diagram, to ensure that the template hole and the bending position of the upper and lower mold clearance with the correct